This flange bolt chart gives the number of studs, the stud diameter and thread, and the raised-face stud length for ASME B16.5 flanges, Class 150 to 2500, NPS 1/2 to 24. Pick a class and pipe size to get a stud and nut count for the job.

Lengths are for raised-face flanges with two heavy hex nuts per stud. Diameters above 1 in. are shown with 8 threads per inch, the usual callout for A193 studs. Check every value against the current ASME B16.5 and your piping specification before you order.

Flange bolt chart by pressure class

Class 150 flange bolt chart

Pipe size (NPS)Studs per flangeStud diameter and threadStud length, raised face (in.)
1/241/2-132-1/4
3/441/2-132-1/2
141/2-132-1/2
1-1/441/2-132-3/4
1-1/241/2-132-3/4
245/8-113-1/4
2-1/245/8-113-1/2
345/8-113-1/2
3-1/285/8-113-1/2
485/8-113-1/2
583/4-103-3/4
683/4-104
883/4-104-1/4
10127/8-94-1/2
12127/8-94-3/4
14121-85-1/4
16161-85-1/4
18161-1/8-85-3/4
20201-1/8-86-1/4
24201-1/4-86-3/4

Questions buyers ask

How do I find the bolt size for a flange?

Look up the flange pressure class and pipe size in the chart. ASME B16.5 sets the number of bolt holes and the bolt diameter for each class and size, so a 4 in. Class 150 flange takes eight 5/8 in. studs and a 4 in. Class 300 flange takes eight 3/4 in. studs.

How is flange stud length measured?

Stud bolts are measured from first thread to first thread, not counting the chamfered points. The raised-face lengths in this chart allow for two heavy hex nuts and a standard gasket.

Which studs and nuts go on a carbon steel flange?

ASTM A193 B7 studs with A194 2H heavy hex nuts are the usual choice. Sour service calls for B7M with 2HM nuts, stainless lines use B8 or B8M with 8 or 8M nuts, low-temperature service uses A320 L7, and high-temperature service uses B16 or A453 Grade 660.

How many nuts does each flange stud need?

Two heavy hex nuts per stud, one on each side of the flange pair. The finder above doubles the stud count to give the nut count for the job.

Are ring-joint flange studs the same length?

No. Ring-type joint flanges sit farther apart, so their studs are longer than the raised-face lengths shown here. Check the RTJ length in ASME B16.5 before you order.

Need flange studs in B7, B16, A286 or stainless?Request a Quote